18.1 - Components

How resistance depends on length and area

• The resistance of a wire depends on the material it's made from, its length, and its cross-sectional area.
• The longer the wire, the greater its resistance.
• The greater the cross-sectional area, the smaller its resistance.
• A long, thin wire therefore has a higher resistance than a short, thick wire of the same material.

Resistance vs length and cross-sectional area

Resistance is proportional to length

Resistance is directly proportional to length (doubling the length doubles the resistance).

Resistance is inversely proportional to area

Resistance is inversely proportional to cross-sectional area (doubling the area halves the resistance).

Diodes

• A diode is a component, usually made from a semiconductor such as silicon, that lets current flow freely in one direction only.
• In the reverse direction it has a very high resistance, so almost no current flows.

Forward and reverse bias

• Forward bias - The direction in which current can flow.
• Reverse bias - The direction in which the diode has high resistance and does not conduct.
• A diode doesn't conduct until the forward voltage reaches a specific threshold value.

Uses

• Used in electronic circuits, such as radio receivers.
• Used to turn alternating current (ac) into direct current (dc).

Light-emitting diodes (LEDs)

• A light-emitting diode (LED) is a diode that emits light when a current flows through it in the forward direction.
• Like any diode, it only lets current flow one way, so it only lights up when connected the right way round.
• LEDs indicate the presence of a current in a circuit, so they're often used in appliances to show they're switched on.

Advantages and uses

• Uses: energy-saving lighting, traffic lights, screens, and remote controls.
• Unlike filament bulbs, LEDs have no filament to burn out.
• They use a much smaller current than traditional filament lamps.